|
<< Click to Display Table of Contents > MOTF Splitting without Splitting |
  
|
|
<< Click to Display Table of Contents > MOTF Splitting without Splitting |
|
By default, it is not possible to use 1D MOTF splitting in combination with Flash.
Though by executing the following steps, static jobs (no serial numbers, etc.) can be executed just as a 1D MOTF split job:
1)Use the Split Preview feature after preparing your split job.
2)Activate Positions as in Job to Mark.
3)Open the Right-Click menu in the View2D of the Split Preview and use Save as to save the job as it is displayed. This will include the correct positioning for the the vectors and the required MOTF Offset and Wait for Trigger entities.
4)Load the job into SAMLight to check whether it works correctly and save it on the card.
5)Afterwards the original job can be marked using Flash as if it was using the splitting feature.
|
The job needs to be static since this method only uses the current vectors of the job and saves them accordingly without any additional information regarding the original objects. |
|---|
