<< Click to Display Table of Contents > 

SAMLight Manual > Splitting > Split Preview > Creating Static Splitting Jobs for Flash

Creating Static Splitting Jobs for Flash 		Previous pageReturn to chapter overviewNext page

By default, it is not possible to use splitting in combination with Flash.

 

Though by executing the following steps, static jobs (no serial numbers, etc.) can be executed just as a split job when using Motion Type 14:

1)Use the Split Preview feature after preparing your split job.

2)Activate both Positions as in Job to Mark and Include Motion Objects

3)Open the Right-Click menu in the View2D of the Split Preview and use Save as to save the job as it is displayed. This will include the correct positioning for the the vectors and the required motion control objects.

4)Load the job into SAMLight to check whether it functions correctly and save it on the card.

5)Afterwards the original job can be marked using Flash as if it was using the splitting feature.

note

The job needs to be static since this method only uses the current vectors of the job and saves them accordingly without any additional information regarding the original objects.