<< Click to Display Table of Contents > Head3 |
Using the option Head2, it is possible to control three 2-axis scan systems with one USC-2 at the same time. Therefor an extra board called "SEB - Scanhead Extension Board" and the corresponding software option is needed. Every scanhead uses its own correction file and head matrix with gain, offset and rotation. The positioning signal to each scanhead is updated all 30 μs.
Figure 19: SEB V1.1 - Scanhead Extension Board
As shown in the picture above the board contains apart from a LED indicator for the 5 V power supply the following connectors:
Name |
Function |
Type |
---|---|---|
USC |
Input from USC-2 X3 connector |
25 pin D-Sub (m) |
USC-HEAD2 |
Input from USC-2 HEAD2 connector |
ML 26 |
HEAD1 |
Output for first scanhead |
25 pin D-Sub (f) |
HEAD2 |
Output for second scanhead |
25 pin D-Sub (f) |
HEAD3 |
Output for third scanhead |
25 pin D-Sub (f) |
GND 5 V |
5 V supply input for the SEB |
Screw clamp |
Table 15: Connectors of the SEB V1.1
The outputs provide the standard XY2-100 interface with X- and Y-channel without Z-channel and the status wire. For further information please contact SCAPS. |
---|