Flash jobs (*.unf) need to be re-created if changes are required or a new SAMLight version is installed.

Modify Jobs:

To modify the jobs, you can follow these steps:

1.Connect the card to your PC.

2.Open SAMLight and load the *.sjf file created during the initial setup.

3.Modify the job according to your needs and save it.

4.Upload the modified job onto your card using the Extras -> Flash dialog.

Afterwards, you can disconnect the card from the PC, re-power the card and mark your job using Flash.

If the system needs to be updated, the following steps need to be taken:

1.Download and install the new version of SAMLight.

2.Connect the card to your PC.

3.Use the Button 'UpdateSystem' in the USC-server to update the firmware version if the server shows "New Firmware available". Reboot the USC-card afterwards.

4.Go to the Hardware Settings (via Settings - System - Optic) and press the 'Store' button to save the current settings which include the update on the card.

5.If there was a bugfix regarding a specific functionality, the following steps should be executed for all jobs containing the functionality:

a.Open SAMLight and load the *.sjf file created during the initial setup.

b.Optionally: Modify the job according to your needs.

c.Save the job.

d.Upload the job back onto your card using the Extras -> Flash dialog.

6.(Optional: Create a copy of the SAMLight settings that where just used, located in <SCAPS>\system folder (The default name is sc_light_settings.sam.) as a backup together with the *.sjf file of the job or generate a backup.zip via SAMLight - Help - 'Generate Backup.zip'.)

Afterwards, you can disconnect the card from the PC, re-power the card and mark your job using Flash.

Defect card / RMA:

If the card should be defect (does not boot any more, etc.), it can easily be replaced by a new card:

1.Connect the new card to your PC.

2.Use the Button 'UpdateSystem' in the USC-server to update the firmware version if the server shows "New Firmware available" or "Firmware newer than available". Reboot the USC-card afterwards.

3.Start SAMLight with the settings corresponding to the card to be replaced.

4.Go to the Hardware Settings (via Settings - System - Optic) and press the 'Store' button to save the settings on the card.

5.Load the *.sjf files and upload them to the card using the Extras -> Flash dialog. Alternatively, if there are a lot of jobs, the *.unf files including the sc_job_list.bin file from the backup.zip folder (Card0 - USC3Flash - jobs) can be uploaded to the card via FTP.

6.(Optional: If you want to make sure no old jobs (for example from quality control) are in the buffer, you can clear the job pool with the FCI command CJP.)

Afterwards, you can disconnect the card from the PC, re-power the card and mark your job using Flash.