<< Click to Display Table of Contents > 1D Planar Splitting |
The 1D Planar Splitting mode is for splitting the current job in one direction, either X or Y, related to the contents displayed in the View 2D. To use this mode at least one axis of the connected motion controller has to be configured for planar operation.
•If an option is grayed out in the splitting settings dialog, it is not possible to use it with the current set splitting option. The availability can be looked up in the following table. •Checked but grayed out parameters are not used. • This mode is not optimized for splitting bitmaps. Therefore, some settings will have no effect, as they target vectors. Those are settings such as Split Overlap, Cog Vectors... etc. They will not be grayed out for bitmaps. |
---|
1D Planar Splitting Parameters |
Vector Marking |
||
---|---|---|---|
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
— |
— |
|
Group Width [a] |
— |
✔ |
— |
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
✔ |
— |
|
✔ |
— |
— |
|
✔ |
— |
— |
|
— |
✔ |
— |
|
— |
✔ |
— |
|
Ungroup Text [b] |
— |
✔ |
— |
✔ |
✔ |
✔ |
|
✔ |
✔ |
✔ |
|
✔ |
— |
— |
Table 50: 1D Planar Splitting Parameters
[a]: This is not available if Top Level Entities as Split Parts is checked.
[b]: Cannot be used in combination with Group Width.
Figure 333: 1D Planar Splitting Dialog