<< Click to Display Table of Contents > Set Override |
Inserting a SetOverride control object into the entity list, the marking speed, the power and the frequency of the applied pen can be changed using the Override functionality of the Mark property page. This is useful for determining the optimal marking speed, power and frequency parameters by marking an array of identical entities with different speed, power and frequency. The test array can be created by copying a row of entities, in which a SetOverride control entity changes one parameter of the following array entity. The value which is set by SetOverride will stay valid even after the marking as long as no other override value is set.
Figure 277: SetOverride Control Object |
Enable: This check box activates the SetOverride control object. Parameter: P/F/S: •P = Power •F = Frequency •S = Speed Value[%]: The override factor is expressed in percent and can be used to increase or decrease the P/S/F value of the pen during the mark process for the marking of all the following entities in the entity list. |
---|
The object SetOverride works also in Flash (it is included in the UNF file). However, the effect is different than in SAMLight: the value does not stay after the marking. This override is not to be confused with the FCI commands OP, OF, OS.