<< Click to Display Table of Contents >  USC Test Manual > Software USC Test > Test Area > Marking On The Fly Section Marking On The Fly Section

The yellow LEDs MOF_CH0 and MOF_CH1 on the DB-37 are blinking when Marking On The Fly encoder signals are pending to the card. The Marking On the Fly signals can also be gripped on the DB-37 at the multi-pin connector "LP_MOF". The indicators 0 and 1 will light up and the bit value is shown.

USC-2:

•To test the second MOF input of the USC-2 a encoder signal can be applied to the MOF multi-pin connector of the USC-2 Test Board.

•Otherwise set the check box "Enable MOTF" to generate a signal and enter a frequency (min. 7.8 kHz). In both cases the indicators 4 and 5 light up with their bit value.