<< Click to Display Table of Contents >  SAMLight Manual > Pen Settings > Edit Pens > Drill Settings > Use Geometry Dialog Use Geometry Dialog

On the drill page of the pen property page, an object can be defined to replace single points. To do so, the "Enable" checkbox under "Use Geometry" needs to be activated. Then, a click on the "Edit" button will open the following dialog (see figure 125) for the specification of the entity with various parameters. The positioning of the entity within the working area (displayed in red in the Edit Drill Geometry dialog) corresponds to the positioning of the entity relative to the point which it should replace.

 

Figure 126: Edit Driill Geometry dialog for specification of the object to be marked at each point position