|
<< Click to Display Table of Contents > Jump |
  
|
|
<< Click to Display Table of Contents > Jump |
|
Inserting a ScJump control object 
into the entity list, creates a jump with the possibility to define specific X, Y, and Z coordinates. Alternatively, the home position can be addressed.
Figure 281: ScJump Control Object |
Enable: This check box activates the ScJump control object. Parameter: X/Y/Z: •X = X coordinate in mm •Y = Y coordinate in mm •Z = Z coordinate in mm Home Position: When activated, the jump parameters from the home position are applied.
A pen can be assigned to the ScJump Control object. The jump speed set in the pen is then used for the ScJump Control object. The home jump is set as the default pen. |
|---|
