<< Click to Display Table of Contents > 

SAMLight Manual > User Interface > Toolbars > Motf Toolbar

Motf Toolbar 		Previous pageReturn to chapter overviewNext page

motf_toolbar

Figure 190: Marking on the Fly Toolbar

The Marking on the Fly toolbar has to be configured once before it can be displayed. The configuration can be done via Global Settings → View → Toolbars → Configuration (Next to Motf) using the following dialog:

 

motf_configuration

Figure 191: Motf Toolbar Configuration

Both channels can be enabled or disabled.
If only one channel gets enabled the toolbar will be smaller in size.
The user can apply the corresponding channel name, set the displayed movement unit and choose the amount of the precision.

 

Name: Enter the Channel name.

Unit: Choose between mm/s and m/min

Precision: Enter the number of decimals.

Enable: Enable or disable the Channels.