|
<< Click to Display Table of Contents > Head ID Selection |
  
|
|
<< Click to Display Table of Contents > Head ID Selection |
|
In MultiHead mode, there is a Head ID drop-down list on the EntityInfo property page to assign the selected entity to the cards.
Figure 490: Head ID Selection Dialog
Head ID of entities |
|
|---|---|
Auto |
Automatic card assignment of entities by MultiHead AutoSplit. |
All |
Entities are marked on all cards. |
Head# |
Manual card assignment of entities to the chosen card. |
Table 65: Head ID of entities
Head ID specialities of Control Objects:
•Groups containing control objects must always be set to Head ID Auto or All. Groups with Head ID Head# that contain control objects are not supported.
•There is no All in the Head ID drop-down list for all control objects. Auto executes OCCO and BCCO on all cards.
•There is no Head ID drop-down list for ScAutoCalib, ScOverride, OGCO and OMCO. The card assignment of ScAutoCalib control objects is defined via the Card ID parameter.