|
<< Click to Display Table of Contents > Option Flash (USC-2/3 only) |
  
|
|
<< Click to Display Table of Contents > Option Flash (USC-2/3 only) |
|
The Flash option is available with an USC-2 or USC-3 card. In the past it was also available with an USC-1 card together with an FEB-1 board. The operation of the flash program is the same for these two setups. The FEB-1 (Flash Extension Board) is an optional card to the USC-1 which allows to store marking jobs which then can be executed in a stand alone mode means without a PC involved. The control in stand alone mode is possible via RS232 commands or the USC-3. USC-2 or USC-1 and FEB-1 digital IO's can be used to select the desired job and start/stop the marking process. The job preparation is done with a PC based editor. The jobs are uploaded to the flash over the same way you connected the card to SAMLight (USB or Ethernet).
Figure 376: USC-2 Card