<< Click to Display Table of Contents >  SAMLight Manual > Entities (Objects) > Barcode > 2D BarCodes > DataMatrix BarCodes > Generate Dots for DataMatrix-Barcode Generate Dots for DataMatrix-Barcode

For marking a data matrix with a design of dots, depending on the data matrix chosen after creating a BarCode, the following can be done:

1.For DataMatrixEx, activate "Generate Dots" in the Extended Dialog.

2.For all other Data matrix types, the following should be done:

a.Create a data matrix and choose the desired data matrix type.

b.Calculate the size of a single module of the data matrix. For quadratic BarCodes:
Size of one single module = x_length of the BarCode/number of cells.

c.In Hatch property page, Hatch the data matrix with the following parameters:

i.Distance = size of one single module.

ii.Start Offset = half of the size of the single module.

iii.Linereduction = very close to the start offset.

d.In the Pen property page -> Drill, Enable "Mark Lines as Dots" and set the grid raster values to the module size .

e.Enable "Use Geometry" and apply a hatched circle with a size smaller than the module.

f.In the Pen property page -> Miscellaneous, disable "Contour" for marking only the dots of the data matrix.