<< Click to Display Table of Contents >  SAMLight Manual > Option Flash (USC-2/3 only) > Handling, Setup and Maintenance > Error Sources > Different SAMLight Settings Different SAMLight Settings

Errors can occur when different settings are saved on the card and on the PC. For more information, please check the chapter on Flash jobs and settings.

In general, SAMLight will warn you should this issue occur when opening Extras - Flash:

Figure 458: Flash Settings Error Message

 

If this state occurs, please check if the SAMLight settings are correct (right card etc.). If you have made recent changed to the settings, go to the Hardware Settings (via Settings - System - Optic) and press the 'Store' button to save the current settings on the card.

If you are unsure, please use the SAMLight settings file from the backup after setup / the job creation.