<< Click to Display Table of Contents > 

FAQ > Basics > Power Supply

Power Supply 		Previous pageReturn to chapter overviewNext page

Each USC card is recommended to be powered via the 37 pin connector. Even short drops of the power can lead to problems of the performance.

Because of significant voltage drop mainly due to the cables between the power supply and the USC card (e.g. 0.3 V for cable of 2 m with 0.25 mm²) , we recommend to measure the current power applied to the card directly at the following places on the USC card:

 

USC-1:

usc_1_power_5V_measure_points

Table 12: Measure USC-1 Power Supply

USC-2:

usc_2_power_5V_measure_points

Table 13: Measure USC-2 Power Supply

USC-3:

usc_3_power_5V_measure_points

Table 14: Measure USC-3 Power Supply