<< Click to Display Table of Contents > 

AEB-2 Manual > Board And Connectors

Board And Connectors 		Previous pageReturn to chapter overviewNext page

Figure 3 shows the connectors and solder jumpers on the top side of the AEB-2, as well as their use.

aeb2_top_con

Figure 3: AEB-2 connectors and solder jumpers

Figure 4 shows the solder jumpers on the bottom side of the AEB-2. The jumpers SJ7 and SJ8 may be used to connect the cable shield to the boards DGND.

note

SJ2, SJ4 and SJ6 must always remain closed, SJ12 must always remain open!

aeb2_bot_sj

Figure 4: Solder jumpers on AEB-2 bottom side