Output synchronous Card-specific Control Object (OCCO):

•ScWaitForInput

•ScSetOutput

•ScSetAnalogOutput

•ScAutoCalib

Synchronous execution on all cards when each card has arrived at that point in the job.

Execution on all cards without any synchronisation.

Buffer synchronous Card-specific Control Object (BCCO):

•ScTimer

•ScOverride

•ScMotfOffset

•ScWaitForTrigger

•ScJump

The BCCO is sent to each card once job preparation for all cards has arrived at its point in the job. Each card executes the BCCO without output synchronization.

Execution on all cards without any synchronisation.

Output synchronous Global Control Object (OGCO):

•ScExecutable

•Sc_RS232

•ScMotionControl
except Type 8 & 14

Execution when each card has arrived at that point in the job.

Not supported.

Output synchronous Motion Control Object (OMCO):

•ScMotionControl Type 8 & 14

Execution on card 0 when each card has arrived at that point in the job. Even if card 0 is not set (SetHead = 1). The job execution of all cards is paused while the OMCO is in progress.

ScMotionControl type 14 control objects in flash mode: Execution on card 0 without any synchronisation. Other combinations are not supported.