<< Click to Display Table of Contents > 

Flash Control Interface Manual > FCI Communication > Control Characters  > Control Characters USC-3

Control Characters USC-3 		Previous pageReturn to chapter overviewNext page

All interfaces of the USC-3 have the same communication protocol which is described in this section.

Telnet and RS-232 interface

Command to USC-3 card

Return from USC-3 card

New line

End of command

New line

End of return

<ESC><CR><LF>

<CR> [a]

<ESC><CR><LF>

<CR>

Table 5: Telnet and RS-232 new line, end of command and end of return control characters.

[a]: Following end of command character is possible: <LF><CR>