<< Click to Display Table of Contents > 

USC-2 Testboard > Board And Connectors > Extension > RS-232 (CH_1)

RS-232 (CH_1) 		Previous pageReturn to chapter overviewNext page

The RxD and TxD lines are defined in respect to the connected device. So the USC-2 RxD pin should be connected to the device RxD pin and the same for the TxD pins. The baud rate can be defined between 2400 and 57600.

note

The RxD and TxD wires must not be crossed, because it is done on the USC-2.