<< Click to Display Table of Contents > 

USC-2 Testboard > Testing with USC-Test > Analog In

Analog In 		Previous pageReturn to chapter overview

Testing the Analog In signals:

1.Connect an instrument cable to a generator. (e.g. 5.5 V / ~1kHz)

2.Cable connection on test board:

a.Use the "GND" or "TP1" header pin for ground

b.Connect the signal to the pins "AI0" and AI1"

3.Click "AnalogIn"

4.Indicators: Both values should jump between 0-1023

note

If you use a different signal from the generator than in our sample, it depends on the generated signal.