Stand-Alone (Flash) Functionality > Flash Job Generation, Upload and Handling

USC-3 Manual > Stand-Alone (Flash) Functionality > Flash Job Generation, Upload and Handling

Flash Job Generation, Upload and Handling

A Flash job can be created / loaded via one of the following ways:

•Create UNF from SJF or CNC and load to card:

oSAMLight -> Extras -> - Flash

oClient Control Interface Command ScProcessFlashJob

oG-Code conversion with Flash command GCF

•Load existing UNF to card:

oSAMLight -> Extras -> - Flash

oClient Control Interface Command ScProcessFlashJob

oVisible USC-Server - Flash

oFTP server and Flash command JLA

	During JobIOSelection mode if a bit is set or a job is being marked, jobs can only be uploaded to the USC-3 card via FTP. They cannot be added to the list with JLA as long as JobIOSelection mode is active.

For further information on flash jobs and settings, see the SAMLight manual.