<< Click to Display Table of Contents > Current Circuits |
The USC card needs up to three power supplies which are provided via the 37-pin connector of the USC card:
•USC main power
•USC opto-coupled outputs and inputs (Opto_Out and Opto_In)
•Optionally: Opto-coupled laser-ports
By default the laser-ports are powered internally. If you want to use opto-isolated mode of the laser-ports you need to adjust JP1 and JP2 on the USC card.
Power supply |
USC 37-pin connector |
Input [Volts] |
Default state |
|
---|---|---|---|---|
USC Main |
EXT_VCC |
pin 24 |
+ 5 |
USB powered (JP4 closed), but not recommended. |
GND |
pins 14, 15, 25 |
|||
USC Opto_Out |
Opto_VCC |
pin 5 |
+ 5 .. + 24 |
Not powered. |
Opto_GND |
pin 6 |
|||
USC Laser-Ports |
EXT_LASER_VCC |
pin 11 |
+ 5 |
Powered via USC main. |
EXT_LASER_GND |
pin 30 |
Table 10: USC power connection