<< Click to Display Table of Contents > Deep Engraving |
This feature is used when the object in the editor should be marked several times at different Z‑heights, e.g. to do deep engraving on a material. The dialog can be accessed via the menu Mark → Z‑Settings.
Figure 437: Deep Engraving Dialog
This is how this feature works:
1. Loop: Z = Start
2. Loop: Z = Start + Step*1
3. Loop: Z = Start + Step*2
...
i. Loop: Z = Start + Step*(i-1)
...
n. Loop: Z = End - Step
After last marking the Depth is equal to End, because the last marking is at End - Step and erodes the Step value. The Z-Settings are being stored within the job file.