<< Click to Display Table of Contents > Min/Max |
By pressing Min /Max... in the Menu Settings → System → Optic dialog following dialog appears. The settings define the range of the values:
•Mark [mm/s]
•Jump Speed [mm/s]
•Frequency [kHz]
•First Pulse [µs] killer length of the laser.
•When using an USC card additional min max values, Working Area X [mm] and Working Area Y [mm] coordinates, can be set to define the working area inside the scanner field.
Figure 54: Min Max Dialog
The Min and Max values of Working Area X and Working Area Y are automatically adapted to the field size values (default), if Size / Center X / Center Y in the optic dialog are being changed. The amount of parameters to set in this dialog can be reduced if an RTC card is used. |
---|
The Min and Max value would be saved in pen settings. So, if "Save Pens on Exit" in General is not enabled, don't forget to click the button "Save Pens Now". Although the Min and Max values are saved in pen settings, after loading a job file with pen settings, the Min and Max values in system would not be overwritten. |
---|
The frequency limit differs for the USC-cards. USC-1/USC-2 with max at 2MHz, USC-3 with max 4MHz. Further information can be looked up in the USC hardware manual. |
---|