<< Click to Display Table of Contents >  SAMLight Manual > sc_setup.exe, Hardware Settings > Hardware Settings > Timing Diagram Laser > CO2 laser CO2 laser

0Laser type 0, version 0, CO2

Figure 37: Timing diagram of default CO2 laser signals

•Opto_Out_0 is the marking in progress (MIP) signal which is activated at the start of the job and closed at the end of the job.

•The Laser_Gate signal is activated with a minimum delay of the job execution delay (JED).

•The pen frequency is used for Laser_A. The power (PWM, duty cycle) of the selected pen is set via the pulse length of Laser_A (according to the power in % which is set in the pen, the Power Map and the overwrite parameter).

•For inactive Laser_Gate signal, the standby frequency is taken for Laser_A with the standby pulse length (if enabled).