|
<< Click to Display Table of Contents > Barcode Reader |
  
|
|
<< Click to Display Table of Contents > Barcode Reader |
|
It is possible to connect a barcode reader to the PC and to read barcodes in SAMLight. Therefore create a serial number entity in the Job. Then in the Serial Number Property Sheet click on the Advanced button. In the window that is popping up activate the checkbox Barcode reader mode in the field Popup edit box. The window will pop up after a finished mark to be filled before the new marking.
Figure 223: Edit serial number dialog
Here you can enter an arbitrary number/letter or, if a barcode reader device is connected to the PC, you can read any barcode with this device and the value of the barcode will be assigned to the serial number in the job.
|
If the barcode reader window is required to pop up before the marking starts, the order can be change by activating "Next Sequence before Mark" in the Settings - General window. |
|---|
