<< Click to Display Table of Contents > Laser Test |
After software startup the LED indicators are on or off, depending on the mode you selected. (Active low = on, active high = off; see also the USC-1 manual) |
---|
The laser has to be safe while testing the laser signals! |
---|
When clicking the button "Laser" the red indicators LAS-G, LAS-A and LAS-B should blink successively and independent from each other. The Laser signals can also be gripped at the multi-pin connector "LASER". The pin assignment is shown in table 11.
Signal |
Indicator |
Pin |
---|---|---|
LaserGate |
LAS-G |
1 |
LaserA |
LAS-A |
2 |
LaserB |
LAS-B |
3 |
Table 11: LASER pin and LED assignment