<< Click to Display Table of Contents > Bottom View |
Figure 4: DB-37 V1.3 bottom view
The bold frame encloses the solder jumpers , which are required for the Opto I/O power supply of the USC. The default position is closed. There are six solder jumpers on the bottom to connect the cable shields with GND.
Version DB-37 |
Jumper Opto I/O |
Cable shields |
---|---|---|
V1.3 |
SJ8, SJ9 |
SJ1, SJ2 and SJ4..SJ7 |
V2.1 |
OGND: SJ1, OVCC: SJ2 |
PE: SJ3..SJ8 |
Table 1: Jumper selection
For all tests, described below, the USC must be connected to a PC and the DB-37 must be connected to the USC. |
---|