<< Click to Display Table of Contents > Copy or Backup Settings |
If you want to update the SAMLight version on your PC, please first make a backup of the system (by copying the 8 files mentioned below to a place safe).
If you want to build up a new system on another PC with the same parameters as the old one - the SAMLight version may be different - , please first install the new SAMLight version and then copy the following 9 files from the old system folder to the new one:
File |
Location |
Description |
---|---|---|
sc_light_settings.sam |
<SCAPS>\system |
settings file |
sc_motion_settings.txt |
<SCAPS>\system |
motion settings |
sc_motion_<MOTION TYPE>_settings.txt |
<SCAPS>\system |
motion stepper settings (depends on the motion type defined in sc_motion_settings.txt, refer to Motion_Controller) |
<SCAPS>\system |
IDs file (only when using multiple cards) |
|
<SCAPS>\system |
configuration file |
|
hosts.allow |
<SCAPS>\system |
|
hosts.deny |
<SCAPS>\system |
|
sc_resource_sc_<LANGUAGE>.sam |
<SCAPS>\system |
Only required if the language is NOT English. |
sc_resource_settings.sam |
<SCAPS>\system |
|
It is also necessary to copy the correction file - for example "cor_neutral.ucf" - from the old system to the new one. The path of the correction file is defined in sc_light_settings.sam. Please refer, depending on the scanner controller card, to chapter Hardware Settings.
Since version 4_0_5_0005 it is possible to use Help - Generate backup zip to generate a backup zip folder.