<< Click to Display Table of Contents > Lookup-Table: Focus Distance Out Of Range |
Figure 17: Focus distance out of range
|
Description |
---|---|
Error Message |
Value out of range |
Cause |
Focus distance is chosen too high. Total SAMLight Z-distance is valid in . |
Solution |
Used bit range [-32768;32767] will be used for each axis. The highest possible dimension in z direction is the fieldsize, which is defined in the middle around z=0. Due to this the Z-Distance in SAMLight is limited. Each control point should be within this range. Other values are not possible. |
Table 37: Description of error 'Focus distance out of range'